一、預處理系統

1、 Preprocessing system

首先通過初、中、高三級過濾法，去除廢氣中的細小顆粒，使有機廢氣滿足沸石轉輪吸附的潔凈度要求；再通過升溫降濕的方法，使有機廢氣滿足沸石轉輪吸附的溫濕度要求；

Firstly, the fine particles in the waste gas are removed through a three-stage filtration method of initial, medium, and high filtration, so that the organic waste gas meets the cleanliness requirements of zeolite wheel adsorption; Then, by using the method of temperature and humidity increase and decrease, the organic waste gas can meet the temperature and humidity requirements of zeolite rotary adsorption;

二、沸石轉輪吸附系統

2、 Zeolite rotary adsorption system

沸石可捕捉到濃度非常低VOCs分子，通過風機的作用，將經過預處理的有機廢氣通過沸石轉輪的吸附區，有機物分子被沸石轉輪*的吸附孔捕捉，吸附達標的氣體直接排入煙囪；

Zeolite can capture VOC molecules with very low concentrations. Through the action of a fan, the pre treated organic waste gas is passed through the adsorption area of the zeolite wheel, and the organic molecules are captured by the adsorption holes of the zeolite wheel. The adsorbed gas that meets the standards is directly discharged into the chimney;

三、脫附系統

3、 Desorption system

經一段時間吸附后，沸石轉輪吸附區會吸附飽和，此時，用小股熱（200~230℃）吹掃沸石轉輪的脫附區，將有機物從沸石中脫附出來后通過風機送入焚燒爐，使沸石再生，如此循環；

After a period of adsorption, the adsorption area of the zeolite wheel will become saturated. At this time, a small amount of heat (200-230 ℃) is used to blow the desorption area of the zeolite wheel, remove organic matter from the zeolite, and then send it to the incinerator through a fan to regenerate the zeolite, and so on;

四、燃燒系統

4、 Combustion system

從沸石分子篩中脫附出的VOCs氣體，通過風機送入rto燃燒系統進行氧化燃燒，把有機廢氣*氧化成水和二氧化碳。

The VOCs gas desorbed from the zeolite molecular sieve is sent to the RTO combustion system through a fan for oxidation and combustion, oxidizing the organic waste gas into water and carbon dioxide.

五、沸石轉輪冷卻系統

5、 Zeolite rotary cooling system

由于沸石經過熱風吹掃脫附后，溫度變高從而無法吸附有機物，此時需要對沸石進行冷卻降溫，使其降到常溫，保證其吸附效率。

Due to the high temperature of zeolite after hot air blowing and desorption, it is unable to adsorb organic matter. At this time, it is necessary to cool the zeolite to room temperature to ensure its adsorption efficiency.

工藝原理：

Process principle:

吸附濃縮：含有VOCs的廢氣由主工藝風機吸入前處理過濾器，由前處理過濾器濾除雜質后的廢氣進入沸石轉輪[CR]，被沸石轉輪吸附處理后的氣體達標排入大氣中。

Adsorption concentration: The exhaust gas containing VOCs is sucked into the pre-treatment filter by the main process fan. After impurities are filtered out by the pre-treatment filter, the exhaust gas enters the zeolite wheel [CR], and the gas after adsorption treatment by the zeolite wheel meets the standard and is discharged into the atmosphere.

脫附燃燒：利用RTO燃燒爐產生的熱量進行熱脫附工藝，清潔空氣由脫附風機進入，經換熱器進入沸石轉輪，熱空氣將沸石加熱，吸附在沸石中的VOCs被脫附出來進入RTO燃燒爐，從燃燒爐中排出的高溫達標氣體通過換熱器實現廢熱利用，終排放至大氣中。

Desorption combustion: Utilizing the heat generated by the RTO combustion furnace for thermal desorption process, clean air enters through the desorption fan and enters the zeolite impeller through a heat exchanger. The hot air heats the zeolite, and the VOCs adsorbed in the zeolite are desorbed and enter the RTO combustion furnace. The high temperature standard gas discharged from the combustion furnace is used for waste heat utilization through the heat exchanger and ultimately discharged into the atmosphere.

本文由沸石轉輪＋RTO為您提供，我們的網站是：http://m.dadmomgo.com我們將以全心全意的熱情為您提供服務，歡迎您的訪問！

This article is provided by Zeolite Wheel+RTO. Our website is: http://m.dadmomgo.com We will provide you with wholehearted enthusiasm and welcome your visit!